Consisting of a stress balanced gear pump, DC motor, multi-functional manifold, valves, tank, ect., this electrical power unit is designed to operate material handling products. The lowering motion is achived through the solenoid valve with the reducing pace controlled by an adjustable needle valve. The left and appropriate functions are equipped by using a dual pilot operated test valve and cross-over relief valves.
Remark: Please seek advice from our income engineer for the different pump displacement, motor energy or tank capacity.
1. This energy unit is of S3 duty cycle, i.e.,non-continuous operation,thirty seconds on and 270 seconds off.
2. Clean every one of the hydraulic parts concerned prior to installation of the energy unit.
three. Viscosity of the hydraulic oil shoud be 15~46 cst, which should really also be clean and cost-free of impurities.N46 hydraulic oil is advisable.
4. This power unit really should be mounted horizontal.
five. Check the oil degree within the tank following the first start from the electrical power unit.
6. Oil altering is needed after the initial one hundred operation hours, afterwards as soon as every 3000 hrs.
SNOW PLOW Energy UNIT